Drylam SL27 Roller Laminator Manual do Utilizador

OWNERS MANUALSL27652792

8D. LaminatingAfter the machine is loaded with film (see B. Loading Film: 1” Mandrel) and threaded (see C. Threading the Film), it is ready to lamina

Note: As the diameter of the film roll decreases, tension should be reduced.To increase tension, turn the adjusting knob clockwise. To decrease tensi

B. Specific Troubleshooting GuideC. Removing a “Wrap-Around”A “wrap-around” occurs if the film exiting the rear rollers curls around one o

Shut the machine off! SL27’s have set screws at both ends of each laminating and pull roller. With the use of a 3/32 hex key, loosen all four set scr

LIMITED WARRANTYDealer, warrants to the original consumer purchaser that each new SL27 Laminator which proves defective in materials or workmanship wi

DRY LAM SL27Parts ListeP ytQnoitpircseD#metI r U/MAE0.13-G LAUNAM NOITAREPO297256AE0.1"52 ,DRAOB GNIDAER

Dry Lam SL27eP ytQnoitpircseD#metI r U/MAE0.4LLOR REBBUR "72108056707901 UPPER ROLL SHAFT ARL-27"

Dry Lam SL27eP ytQnoitpircseD#metI r U/MAE0.4SLEWOD LLOR RELDI260707802155 PRESSURE SPRING, MINIKOTE 2.0 EA707

CONTENTSSection Index Specifications ...

SPECIFICATIONSHeight ... 15”Width ...

IMPORTANT SAFEGUARDS2• Read all the safety and operating instructions before connecting or using this unit.• Retain this notice and the owners man

GENERAL DIAGRAMS3ABCThe SL27, offers a reverse feature. They are designed to laminate a variety of materials using up to 27” laminating film. The SL

GENERAL DIAGRAMS4DEJ G H K L IFNM

5I. UnpackingRemove the laminator from its box by grasping the housings and pulling up. Do not use rollers or shafts as handles - this could cause dam

6B. Loading Film: 1” Mandrel (K)Unpack the upper and lower supply man-drels. The upper and lower mandrels are different. The word “TOP” is

C. Threading the FilmRemove the feed tray and the heatguard. Thread the film as shown in the figure on the right. Pull the film around the idler ro